Remote Control Extenders
-
Draper IR/RF Transceiver
C156.261 - ReCharge Arc Wi-Fi to 433 2 Way RTS Bridge Kit
Learn More$137.45 -
Draper Wireless Transmitter, RF Type, WRT
Hand-held radio frequency transmitter (WRT). 3-button control lets you stop or change direction at any point. For use with LVC-IV Low Voltage Control Module.
Learn More -
C2G 10ft Dual Infrared (IR) Emitter Cable
Plug this IR emitter into a 2-conductor 3.5mm keystone jack and stick it over the IR eye on your audio/video equipment. The emitter operates on 12 VDC and is compatible with most IR devices. Put your components where they belong, not where you see them! You can even control audio/video devices located behind doors or in other rooms.
Learn More -
C2G 10ft Single Infrared (IR) Emitter Cable - 10 ft Cable Length
Ideal for use with #40430, Remote Control Repeater Kit. Plug this IR emitter into a 2-conductor 3.5mm keystone jack and stick it over the IR eye on your audio/video equipment. The emitter operates on 12 VDC and is compatible with most IR devices. Put your components where they belong, not where you see them! You can even control audio/video devices located behind doors or in other rooms.
Learn More -
ATEN IR Emitter
ATEN IR Emitter Learn More -
Atlas Learn Two Channel Infrared Dome Receiver - 2.80 MHz
The Atlas Learn AL-EAGLE infrared receiver is a two channel infrared receiver that is designed to work with Atlas Learn infrared infrared microphones, AL-MAGPIE and AL-MYNA. The AL-EAGLE connects via RCA output to almost any local audio amplifier. This allows teachers and students to walk freely around the classroom with the infrared microphones/system control units and project their voices through connected, installed speakers.
The AL-EAGLE also features a contact closure output that can be connected to a secondary system allowing the teacher to signal an emergency situation in the classroom using the "Panic" feature on the AL-MAGPIE or AL-MYNA wireless transmitters (in "teacher" mode only). For larger rooms, the AL-EAGLE has an F-pin style input connector that is designed to be used with a secondary infrared wireless dome, AL-IRDS, if needed. Volume controls for the two wireless transmitters are located on the side of the AL-EAGLE to properly set or adjust transmitter volume internally mixing the two channels for output to the amplifier. Three LEDs are located on the front of the unit and act as visual indicators for system power and connection.
Learn More$410.38
